Duet3D
/
/

Site Navigation

Your Account

Choose Language

Changes to Step #8

Edit by Ian A-S —

Edit approved by Ian A-S

Before
After
Unchanged

Step Lines

[title] Enable Network Module
[* black] For '''Duet 2 WiFi''':
[* icon_note] The WiFi module has a blue LED on it, just next to the Micro SD card holder. This should flash once when power is connected to the board, but will only be lit permanently if it is connected to a WiFi network. Duets with an external antenna use a different WiFi module, with no indicator LED.
[* icon_note] The WiFi module has a blue LED on it, just next to the Micro SD card holder. This should flash once when power is connected to the board, but will only be lit permanently if it is connected to a WiFi network. Duets with an external antenna use a different WiFi module, with no indicator LED.
[* black] You may find you are getting a lot of messages like ''"WiFi reported error: no known networks found"''. The default configuration turns on the WiFi, but it is not finding a network to connect to. To stop the WiFi, send '''M552 S-1'''.
[* black] Send '''M552''' to check the status. It should say ''"WiFi module is disabled"''. Now put it into idle mode by sending command '''M552 S0'''. Send '''M552''' again to check it's in idle, then proceed to the next step.
[* black] For '''Duet 2 Ethernet''' and '''Duet 2 Maestro''':
[* black] Send '''M552''' to check the network module status.
[* black] It may report that the module is disabled or enabled. Put it into disabled mode by sending command '''M552 S0'''. Send '''M552''' again to check it is disabled, then proceed to the next step.