Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #8

Edit by Ian A-S

Edit approved by Ian A-S

Before
After
Unchanged

Step Lines

[title] Enable Network Module
[* black] First, checkFor '''Duet 2 WiFi''':
[* icon_note] The WiFi module has a blue LED on it, just next to
the status ofMicro SD card holder. This should flash once when power is connected to the Wifi or Ethernet Module by sending command "M552"board, but will only be lit permanently if it is connected to Duet.
[*
a WiFi network.
[*
black] For Duet 2 Wifi, itYou may respond thatfind you are getting a lot of messages like ''"WiFi reported error: no known networks found"''. The default configuration turns on the WiFiWiFi, but it is not finding a network to connect to. To stop the WiFi, send '''M552 S-1'''.
[* black] Send '''M552''' to check the status. It should say ''"WiFi
module is disabled, idle or running. Putdisabled"''. Now put it into idle mode by sending command '''M552 S0'''. Send '''M552''' again to check it's in idle, then proceed to the next step.
[* black] For Duet'''Duet 2 EthernetEthernet''' and Maestro, it'''Duet 2 Maestro''':
[* black] Send '''M552''' to check the network module status.
[* black] It
may report that the module is disabled or enabled. Put it into disabled mode by sending command '''M552 S0'''. Send '''M552''' again to check it is diableddisabled, then proceed to the next step.
[* black] First, checkFor '''Duet 2 WiFi''':
[* icon_note] The WiFi module has a blue LED on it, just next to
the status ofMicro SD card holder. This should flash once when power is connected to the Wifi or Ethernet Module by sending command "M552"board, but will only be lit permanently if it is connected to Duet.
[*
a WiFi network.
[*
black] For Duet 2 Wifi, itYou may respond thatfind you are getting a lot of messages like ''"WiFi reported error: no known networks found"''. The default configuration turns on the WiFiWiFi, but it is not finding a network to connect to. To stop the WiFi, send '''M552 S-1'''.
[* black] Send '''M552''' to check the status. It should say ''"WiFi
module is disabled, idle or running. Putdisabled"''. Now put it into idle mode by sending command '''M552 S0'''. Send '''M552''' again to check it's in idle, then proceed to the next step.
[* black] For Duet'''Duet 2 EthernetEthernet''' and Maestro, it'''Duet 2 Maestro''':
[* black] Send '''M552''' to check the network module status.
[* black] It
may report that the module is disabled or enabled. Put it into disabled mode by sending command '''M552 S0'''. Send '''M552''' again to check it is diableddisabled, then proceed to the next step.