Duet3D
/
/

Site Navigation

Your Account

Choose Language

Changes to Step #7

Edit by Filastruder —

Edit approved by Filastruder

Before
After
Unchanged

Step Lines

[title] Check your Firmware Version
[* black] Open a 3D host programYAT, and configure the correct COM port.
[* black] If unsure, press Ctrl + R on your keyboard and type ++devmgmt.msc++
[* black] Your Duet will be listed under ++Ports (COM & LPT)++ as ++USB Serial Device (COM#)++ or similar. Use COM# as the com port in YAT.
[* red] After COM port has been configured, send command "M115" to the Duet board.
[* yellow] The Duet will return the firmware version being used.
[* black] If using firmware version 1.19 or later, continue to the next step.
[* black] If using firmware version 1.18 or earlier, skip to step ##
[* black] Open a 3D host programYAT, and configure the correct COM port.
[* black] If unsure, press Ctrl + R on your keyboard and type ++devmgmt.msc++
[* black] Your Duet will be listed under ++Ports (COM & LPT)++ as ++USB Serial Device (COM#)++ or similar. Use COM# as the com port in YAT.
[* red] After COM port has been configured, send command "M115" to the Duet board.
[* yellow] The Duet will return the firmware version being used.
[* black] If using firmware version 1.19 or later, continue to the next step.
[* black] If using firmware version 1.18 or earlier, skip to step ##

Image 1

No previous image

Added