Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #13

Edit by Ian A-S

Edit approved by Ian A-S

Before
After
Unchanged

Step Lines

-[title] Optional - Set a static IP for Duet 2 Ethernet or Duet 2 Maestro
-[* black] Optional: Set the IP address for the Duet controller in the M552 command.
- [* icon_note] Leaving this as 0.0.0.0 will allow your router to assign an IP address via DHCP. This is standard for most network devices.
- [* icon_caution] If you are not familiar with networking, you should leave this setting as 0.0.0.0.
+[title] Set the IP address for Duet 2 Ethernet or Duet 2 Maestro
+[* icon_note] The ***Duet 2 Ethernet*** and ***Duet 2 Maestro*** come with a factory-configured fixed IP address for testing. In step 8 you set up network access temporarily. You now need to change the config.g so you can access the Duet Web Console (DWC) following a power cycle.
+[* black] ***For DHCP:***
+ [* black] Most home routers are setup to assign IP addresses by DHCP. Change the M552 P192.168.1.14 line in config.g to ***M552 P0.0.0.0*** to have your router assign an IP address via DHCP. This is standard for most network devices. Any other network settings are set automatically.
+ [* icon_caution] If you are not familiar with networking, you should change this setting to M552 P0.0.0.0
+[* black] ***For Fixed IP address:***
+ [* black] You can set the Duet to use a fixed IP address. Note that if you use a fixed address, care should be taken that it does not conflict with other devices on the network. Change the M552 P192.168.1.14 line to the IP address you want to use, eg M552 P192.168.0.15
+ [* black] You may also need to change the M554 (Gateway) and M553 (Netmask) commands to match your network.