Changes to Step #10
Step Lines
[title] Duet 2 Ethernet and Duet 2 Maestro - Enable Ethernet Connection [* black] '''DHCP.'''If you have setup the Duet 2 Ethernet to use DHCP then when the network is enabled it will look for a DHCP server to allocate an address. Most home routers are setup to assign addresses by DHCP. |
[title] Duet 2 Ethernet and Duet 2 Maestro - Enable Ethernet Connection [* black] '''DHCP.'''If you have setup the Duet 2 Ethernet to use DHCP then when the network is enabled it will look for a DHCP server to allocate an address. Most home routers are setup to assign addresses by DHCP. |
[* black] Send the command "M552 S1" to the board. |
[* black] After about 30 seconds, the board should reply with '''Network running''' and the IP address that the Duet has been assigned. |
[* black] '''Fixed Address''' If you have used a fixed IP address in config.g then when the network is enabled the Duet 2 Ethernet will use that address. Note that if you use a fixed address, care should be taken that it does not conflict with other devices on the network. [* icon_caution] The Duet 2 Ethernet and Duet 2 Maestro come with a factory configured fixed address used during testing. This address will probably not work with your network and may cause conflicts. It is recommended to enable DHCP when using the [https://configurator.reprapfirmware.org/|RepRapFirmware configurator]to generate your configuration file. |
[* black] '''Fixed Address''' If you have used a fixed IP address in config.g then when the network is enabled the Duet 2 Ethernet will use that address. Note that if you use a fixed address, care should be taken that it does not conflict with other devices on the network. [* icon_caution] The Duet 2 Ethernet and Duet 2 Maestro come with a factory configured fixed address used during testing. This address will probably not work with your network and may cause conflicts. It is recommended to enable DHCP when using the [https://configurator.reprapfirmware.org/|RepRapFirmware configurator]to generate your configuration file. |
[* icon_note] Mac users: Press CRTL-A and then CRTL-D to exit screen and return to terminal. You can safely close Terminal at this point. |