Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #8

Edit by Tony

Edit approved by Tony

Deleted
Added
Unchanged

Step Lines

[title] Duet Ethernet - Enable Ethernet Connection
[* black] '''DHCP.'''If you have setup the Duet Ethernet to use DHCP then when the network is enabled it will look for a DHCP derver to allocate an address. Most home routers are setup to assign addresses by DHCP.
[*
black] Send the command "M552 S1" to the board.
[*

[*
black] After about 30 seconds, the board should reply with '''Network running''' and the IP address that the Duet has been assigned.
[* black] '''Fixed Address''' If you have used a fixed IP address in config.g then when the network is enabled the Duet Ethernet will use that address. Note that if you use a fixed address, care should be taken that it does not conflict with other devices on the network.
[* icon_caution] The Duet Ethernet comes with a factory configured fixed address used during testing. This address will probably not work with your network and may cause conflicts. It is recommended to enable DHCP when using the [https://configurator.reprapfirmware.org/|RepRapFirmware configurator]to generate your configuration file.
[* black] '''DHCP.'''If you have setup the Duet Ethernet to use DHCP then when the network is enabled it will look for a DHCP derver to allocate an address. Most home routers are setup to assign addresses by DHCP.
[*
black] Send the command "M552 S1" to the board.
[*

[*
black] After about 30 seconds, the board should reply with '''Network running''' and the IP address that the Duet has been assigned.
[* black] '''Fixed Address''' If you have used a fixed IP address in config.g then when the network is enabled the Duet Ethernet will use that address. Note that if you use a fixed address, care should be taken that it does not conflict with other devices on the network.
[* icon_caution] The Duet Ethernet comes with a factory configured fixed address used during testing. This address will probably not work with your network and may cause conflicts. It is recommended to enable DHCP when using the [https://configurator.reprapfirmware.org/|RepRapFirmware configurator]to generate your configuration file.
[* icon_note] Mac users: Press CRTL-A and then CRTL-D to exit screen and return to terminal. You can safely close Terminal at this point.