Skip to main content
WARNING! From February 2022, these pages are no longer maintained.
Please see the current Duet3D documentation at

Site Navigation

Your Account

Choose Language

Changes to Step #10

Edit by Tony

Edit approved by Tony


Step Lines

-[title] (Delete?) Enable Ethernet Connection
-[* black] Open the ***sys/config.g*** file located on the SD card.
-[* red] Set the parameter S1 in the M552 command to enable networking.
-[* red] Ensure there is no semicolon before the M552, a semicolon tells the printer to ignore that line.
+[title] Duet Ethernet - Enable Ethernet Connection
+[* black] Send the command "M552 S1" to the board.

Image 1