Skip to main content
WARNING! From February 2022, these pages are no longer maintained.
Please see the current Duet3D documentation at

Changes to Step #8

Edit by Jason Znack

Edit approved by Jason Znack


Step Lines

[title] Testing the Bed Heater
[* black] Command the bed temp to 50c.
[* black] Watch the temp graph to see if it stabilizes.
+[* black] Test the part cooling blower with the fan speed slider on the right side of the screen. Note if it has an effect on the hot end temperature.
[* black] As the hot end temp drops below 45c the hot end fan should turn off and the case fan should continue to spin.
[* black] Turn the bed heater off (0c).
[* black] When the bed temp drops below 45c the case fan should stop spinning.
[* black] If you encounter a heater fault, check this page: [[Spurious heater faults and how to avoid them]]