Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #15

Edit by Jason Znack

Edit approved by Jason Znack

Deleted
Added
Unchanged

Step Lines

[title] Reassembly - Onto Frame
[* black] Once you’ve got everything wired up you can reinstall the case onto the frame.
[* black] You may find it easier to disconnect some wires temporarily and reconnect them once it’s installed. It’s a tight fit, but it will all fit. I suggest leaving the 2 screws on the front loose and align and tighten the screw directly under the bed first.
[* black] Note that the VIN power, Bed wires, and hot end wires stick out from the edges of the board and will press up against the side of the case slightly. For the VIN and bed wires you will need to bend the spade connector upwards to fit back onto the frame.
[* black] Once you’ve got all your wires reconnected, you can use some zip ties, etc., to provide some strain relief for the bundle leaving the case.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added