https://docs.duet3d.com/

Changes to Step #10

Edit by Tim

Edit approved by Ian A-S

Before
After
Unchanged

Step Lines

[title] Check Endstop Configuration
[* black] You should have already checked for proper operation of endstops. At this time, we will make sure that they are correctly configured.
[* black] Navigate to the console.
-[* black] Send M119 - you will see the state of the endstops, will allbe non triggered, then hold each one down in turn, while sending M119 again and confirm the state changes to triggered.
+[* black] Send M119 - you will see the state of the endstops, will all be non triggered, then hold each one down in turn, while sending M119 again and confirm the state changes to triggered.