https://docs.duet3d.com/

Changes to Step #10

Edit by Tony

Edit approved by Tony

Before
After
Unchanged

Step Lines

[title] Check Endstop Configuration
[* black] You should have already checked for proper operation of endstops. At this time, we will make sure that they are correctly configured.
-[* black] Navigate to Settings, then Machine Properties to check the status of your endstops. Observe the actual status of the endstops on your printer and make a note if the indicated status is incorrect.
-[* black] If any endstops are not configured properly, we will fix them in the next step.
+[* black] Navigate to the console.
+[* black] Send M119 - you will see the state of the endstops, will allbe non triggered, then hold each one down in turn, while sending M119 again and confirm the state changes to triggered.

Image 1

Deleted