Skip to main content
WARNING! From February 2022, these pages are no longer maintained.
Please see the current Duet3D documentation at
Create a Page
1.) Getting Connected to your Duet Introduction
Dec 17, 2020
Edit approved by
'''This document is relevant to:''' Duet 2 WiFi / Ethernet, Duet 2 Maestro, and
Duet 3 MB6HC and Mini 5+
WiFi / Ethernet
in stand alone mode.
'''Firmware versions:''' All versions
This guide covers getting a basic USB connection to your Duet, setting it up to be connected to your network, and connecting to the Duet Web Console using a browser.
If you are setting up a '''Duet 3 with connected Single Board Computer''' (SBC, eg Raspberry Pi), please see [https://duet3d.dozuki.com/Wiki/SBC_Setup_for_Duet_3|SBC setup for Duet 3] documentation.
If you have any problems with your Duet when using this guide, rather than posting comments, '''please use our support forum: https://forum.duet3d.com/ '''
Unboxing and initial connection to a Duet 2 Wifi
, Duet 2
Maestro, Duet 3 MB6HC
3 Mini 5+ WiFi / Ethernet