Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Ender 3 Pro and Duet Maestro Guide Part 4: Calibration Introduction

Edit by Jason Znack

Edit approved by Jason Znack

Deleted
Added
Unchanged
Title
4: Tuning Calibration
4: Tuning Calibration
Introduction
In the previous guides in this series we went through installing a Duet 2 Maestro in a stock Ender 3 Pro, configured RepRapFirmware to work with it, and tested all of the hardware and electronics. [ … ] https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+1:+Wiring/37 https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+2:+Configuration/38 https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+3:+Commissioning/39 [ … ] In this 4th and final guide in the Ender 3 series, we will go through initial calibration of the printer to determine crucial print parameters. [ … ] Though this guide is specific to the Ender 3, the procedures shown here are the same for any printer during initial calibration.
Time Required Min
1 hour
Time Required Max
2 hours
Imageid
Before
After
Difficulty
Moderate
Easy
Public
No
Yes
Summary
- Tuning Calibration of basic parameters to get good prints right from the start.
- Tuning Calibration of basic parameters to get good prints right from the start.

Steps

Step #: 1
Before
After
Step #: 2
Before
After