Skip to main content
WARNING! From February 2022, these pages are no longer maintained.
Please see the current Duet3D documentation at
Ender 3 Pro and Duet Maestro Guide Part 3: Commissioning Introduction
May 14, 2019
Edit approved by
Ender 3 Pro and Duet Maestro
Guide Part 3:
In the previous two guides, we connected all the wiring, and prepared the SD card with all the configuration files needed and connected to the printer.
This guide will cover the first steps you should take once connected to the Duet Web Control to safely verify that your hardware is connected and configured correctly.
Though this guide is specific to the Ender 3, the procedures shown here are the same for any printer during first commissioning.